Raspberry Pi and a cardboard robot…

This is a little demo of a robot that took a few minutes to make. I had scanned the artwork of a cardboard toy robot kit and then shrunk it to A4. I printed out on thin card (a bit too thin as it happens…) and then shoved in a couple of servos which only just fit.

There’s a simple python program outputting random PWM signals via ServoBlaster.

It’s nothing special, but it might give some inspiration for someone to take further. Perhaps it could really be a Dalek, Wall-E or “Buddy” from Q Pootle 5.

In addition, I’ve created a new version of my ServoBlaster buffer board using a 74HC541 this time. At some stage I’ll post an artwork and circuit diagram.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s